The analysis has identified the following job as a problem area. Complete a flow process chart $($material type$)$ for the following engine stripping, cleaning, and the degreasing operation. Engines are stored in the engine storeroom. When needed an engine is picked up by and electric hoist on mono rail, transported to the stripping day, and unloaded onto an engine stand. There the operator strips in the engine, putting the engine parts into the degreasing bucket. The bucket is transported to the degreaser, loaded into the degreaser, degreased, and then unloaded from the degreaser. The bucket with degreased engine parts is then transported to the cleaning area, where the parts are simply dumped on the ground for drying. After several minutes of drying, the parts are lifted to the cleaning benches and cleaned. The cleaned parts are collected in special trays to await transport. The parts loaded on the trolley and transported to the inspection section. There they are slid from trays on to the inspection benches.