The answer to the table given by teacher is:

RegDst-0

Jump-x

Branch-1

MemRead-1

MemtoReg-x

ALUop-1

MemWrite-x

ALUSrc-1 (not sure about this one, please give your answer)

RegWrite-x

x means the signal cannot be set in this instruction.

Could you explain the answer in details?

5. (35 points) We wish to add the single cycle datapath and control. Add an a new instruction im Gump memory) to page. This necessary datapaths and control signals to the attached figure on next new jump instruction bm SI, S2, 100 writes PC with the value in memory location 0, i.e., PC (next PC)+memory [$2-100]. The format is the same as lw except that ri field is not used. Give control values of all the control lines for jm. Add more control lines if necessary RegDst Jump Branch MemRead T MemtoRe Reg Write ALUo Mem Write ALUSrc