Question: What does the command no shutdown accomplish when configuring a switch port interface? ###answer### It saves the current configuration. It disables the interface. It resets

What does the command no shutdown accomplish when configuring a switch port interface?
###answer###
It saves the current configuration.
It disables the interface.
It resets the interface to default settings.
It enables the interface.

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Programming Questions!

Q:

Mini Project Networking-II (Routing and Switching Essentials) Introduction In this practice skills assessment, you will configure the Sohar University network. You will perform basic router...

Q:

cisco packet tracer 1 / 9 100% + Laboratory Project II IOS Networking Essentials This laboratory project introduces students to simple iOS networking tasks such as interface configuration, DHCP,...

Q:

Using Cisco packet tracer complete and ignore all questions. All that is NEEDED is: Topology diagram - (screenshot) this will display the connectivity of the network devices and should match the...

Q:

Topology Note: Do not use 2960 switches. You must select the 3560 model switch in Packet Tracer as shown below. 2960s will not support IPv6 in Packet Tracer. Assessment Objectives Part 1: Configure...

Q:

3 / 9 100% + Objective II: Study serial defaults Enter a command on Router that reports the status and parameters of the interface Serial0/0/0. What's the interface's Physical and Data Link layers'...

Q:

Topology Note: Do not use 2960 switches. You must select the 3560 model switch in Packet Tracer as shown below. 2960s will not support IPv6 in Packet Tracer. Assessment Objectives Part 1: Configure...

Q:

Overview and Objectives This case study allows students fully Design a complex network using skills gained throughout the course but build and configure only a prototype as seen in the following...

Q:

Lab Task 4: Configure R1 for Inter-VLAN Roliting Configure the router on the Office 1 network to allow multiple VLANs to communicate on the network. Perform steps 14 on R1. 1 Enable GigabitEthernet...

Q:

Packet Tracer - Basic Switch Configuration - Physical Mode Topology Addressing Table Device Interface IP Address / Prefix S 1 S 1 S 1 VLAN 9 9 VLAN 9 9 VLAN 9 9 1 9 2 . 1 6 8 . 1 . 2 / 2 4 2 0 0 1...

Q:

Topology Assessment Objectives Part 1: Develop the IPv4 Address Scheme (20 points, 25 minutes) Part 2: Initialize and Reload Devices (10 points, 10 minutes) Part 3: Configure Device IPv4 and Security...

Q:

Practical Application: You own a furniture manufacturing company that employs 200 people, many of whom have worked for you for over 20 years. Although your company is profitable, you could raise your...

Q:

Find the linearization of the function z = x, at the point (-6, 4). L(x, y) = %3!

Q:

Board - designated restrictions are reported as net assets with restrictions. Question 2 0 Select one: True False

Q:

iviarshmallow h h last try: 0 of 1 pts. See Details for et a similar question You can retry is a function with f(17) = 15 and he following values of f.