Question: The parasailing system shown uses a winch to pull the rider in towards the boat, which is travelling with a constant velocity. During the interval

The parasailing system shown uses a winch to pull the rider in towards the boat, which is travelling with a constant velocity. During the interval when ( is between 20Âº and 40Âº, (where t = 0 at ( = 20Âº) the angle increases at the constant rate of 2 Âº/s. During this time, the length of the rope is defined by the relationship r = 125 - 1/3 t3/2, where r and t are expressed in meters and seconds, respectively. At the instant when the rope makes a 30 degree angle with the water, the tension in the rope is 18 kN. At this instant, what is the magnitude and direction of the force of the parasail on the 75 kg parasailor?

Step by Step Solution

★★★★★

3.44 Rating (176 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

Given Kinematics Using Radial and Transverse ... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Document Format (1 attachment)

1221-P-M-K(2212).docx

120 KBs Word File

Students Have Also Explored These Related Mechanics Questions!

The boat has a mass of 180 kg and is traveling forward on a river with a constant velocity of 70 km/h, measured relative to the river. The river is flowing in the opposite direction at 5 km/h. if a...

A ski boat moves with constant velocity. Is the net force acting on the boat doing work? Explain.

A prospector uses a hand-powered winch (see figure) to raise a bucket of ore in his mine shaft. The axle of the winch is a steel rod of diameter d = 0.625 in. Also, the distance from the center of...

The parasailing system shown uses a winch to pull the rider in toward the boat, which is traveling with a constant velocity. During the interval when is between 2 0 and 4 0 ( where t = 0 at = 2 0 ) ,...

Required information Problem 1 2 . 1 2 7 - Particle kinetics - curvilinear motion, radial and transverse coordinates - DEPENDENT MULTI - PART PROBLEM - ASSIGN ALL PARTS NOTE: This is a multi - part...

Some parasailing systems use a winch to pull the rider back to the boat. During the interval when is between 2 0 and 4 0 , ( where t = 0 at = 2 0 ) the angle increases at the constant rate of 2 % s ....

1. What is a tangent line and what is it used for? Sketch an example. 2. What value is the slope of a v vs t graph for a free-falling object? Why? 3. If wind resistance was included in the previous...

6. A satellite in space is travelling at 14 m/s in one direction. A thruster is applied for 30. s and the satellite is then travelling at 12 m/s in the opposite direction. What acceleration does the...

166 1. A weightlifter uses a force of 375 N to lift weights directly upward through a distance of 0.85 m. Determine the work done on the weights by the weightlifter. 2. A tow truck uses a winch with...

Answer the following on paper 1. What is the kinetic energy of a wagon of mass 15 kg whose momentum is 60 kg .m/s? [2 marks] 2. A sledge hammer has a mass of 4.0 kg and is moving down at a speed of...

In a bend in a stream, as in Fig. 9.4, where will the stream deposit sediment, and where will it erode sediment?

The heating capacity of a calorimeter is known to be 4 kJ/oC, with negligible uncertainty. The number of dietary calories (kiloCalories) per gram of a substance is given by C = cH(T )/m, where C is...

The Trial Balance of Dilip and Co, showed a difference. On scrutiny of the books, the following errors were detected: (a) Total of the debit side of the Stationery Account has been overcast by ~ 100....

4.12 At what percentile is the third quartile?

Determine the kinetic energy of the disk of Prob. 18.7. Problem 18.7: A homogeneous disk of mass m = 8 kg rotates at the constant rate 1 = 12 rad/s with respect to arm OA, which itself rotates at the...

Determine the kinetic energy of the disk of Prob. 18.8. Problem 18.8: A homogeneous disk of mass m = 6 kg rotates at the constant rate 1 = 16 rad/s with respect to arm ABC, which is welded to a shaft...

Determine the kinetic energy of the assembly of Prob.18.15. XHE 200 mm 200 mm 200 mm 200 mm

Ashley Limiteds overhead costs of $700,000 consist of machining $400,000; inspecting $200,000; and packaging $100,000. Machining works 4,000 hours a year, 500 inspections occur each year, and 1,000...

ANSWER ALL FOR THUMBS IF ONLY ONE IS ANSWERED I WILL GIVE THUMBS DOWN 1.1 1.2 1.3 (Yield to maturity) Fitzgerald's 15-year bonds pay 11 percent interest annually on a $1,000 par value. If the bonds...

what is the answer? please and thanks. A stock is trading for a share price of $21.61. You expect it to pay a dividend of $136 exactly one year from now, and you expect future annual dividends to...