Question: An industrial load that consumes 80 kW is supplied by the power company through a transmission line with 0.1 ohms resistance, with 84kW. If the

An industrial load that consumes 80 kW is supplied by the power company through a transmission line with 0.1 ohms resistance, with 84kW. If the voltage at the load is 440 Vrms, find the power factor at the load.

Step by Step Solution

★★★★★

3.33 Rating (168 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

The question is complete Lets proceed with the answer To find the power factor at the load we need t... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

An industrial load that consumes 40 kW is supplied by the power company, through a transmission line with 0.1- resistance, with 44kW. If the voltage at the load is 240 V rms, find the power factor at...

A transmission line with impedance 0.08 j 0.25 ohms is used to deliver power to a load. The load is inductive and the3 load voltage is 220 0 V rms at 60 Hz. If the load requires

A transmission line with impedance 0.1 + j0.2 is used to deliver power to a load. The load is capacitive and the load voltage is 240

Consider a radial transmission power system shown in Fig.1 with the nominal bus voltage Vo = Vozdo before the transformer, the sending bus voltage V, V.Zd, after transformer and the receiving bus...

An industrial load is supplied through a transmission line that has a line impedance of 0.1 + j0.02 . The 60-Hz line voltage at the load is 480

The power company must generate 100 kW in order to supply an industrial load with 94 kW through a transmission line with 0.09  resistance. If the load power factor is 0.83 lagging, find the...

this is the figure Do some energy and cost saving analysis if ice storage is to be adopted for Air conditioning purposes for a space that has a sensible cooling load of 100 kW and a latent heat load...

Question 1: The flux per pole in a synchronous motor with the field circuit ON and the startor disconnected from the supply is found to be 25 mWb. When startor is connected to the rated supply with...

1. Using stress-strain diagrams, show the difference in deformation response between elastic and linear viscous (newtonian) materials. Label your diagrams 31. List three types of material objects...

Birds resting on high-voltage power lines are a common sight. The copper wire on which a bird stands is 2.2 cm in diameter and carries a current of 50 A. If the birds feet are 4.0 cm apart, calculate...

Baxter Pauline established Summit Services, P.C., a professional corporation, on December 1 of the current year. Summit Services offers financial planning advice to its clients. The effect of each...

Total taxes before adjustments are $ 7 , 8 0 3 . 1 5 , total deposits for the quarter are $ 7 , 8 0 3 . 1 7 , and the difference between the amounts is due to rounding. On what line of Form 9 4 1 is...

If there are dried-up riverbeds on Mars, then water once flowed on the Martian surface. There are dried-up riverbeds on Mars. Therefore, water once flowed on the Martian surface. (D, W) Translate the...

Polycorp is about to issue debentures. The following information is available. 1. The coupon rate is 8% pa (or .08). Coupons are paid annually 2. The yield to maturity (YTM) is 0.09 pa 3. The face...

Fun Land is considering adding a miniature golf course to its facility. The course would cost $63000, would be depreciated on a straight line basis over its 4-year life, and would have a zero salvage...

The McDonalds Company plans to open a new branch office in a suburban area. The building will cost $200,000 and will be depreciated (on a straight-line basis) over a 20 year life to a $0 estimated...