Question: How to do the objcetives with step ( the commands ) Objectives: Configure IP addresses Configure static route Test ( point to point ) :

How to do the objcetives with step ( the commands )
Objectives:
Configure IP addresses
Configure static route
Test (point to point):
PC0 to PC1;
Server0 to PCO
Assumptiom: 1) WAN link failure only, router doesn't fail
There is no simultaneous failure of two WAN links
Objectives:
Configure IP addresses
Configure static route
Test (point to point):
PCO to Sever1
How to do the objcetives with step ( the commands )

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Databases Questions!

Q:

Lab 1: Introduction to Packet Tracer Lab 1: Introduction to Packet Tracer Total Marks= 10 Objectives of this Lab: The goal of this lab is to become familiar with building topologies in Packet Tracer...

Q:

Cisco Networking Academy Mind Wide Open Lab 1.5.2: Basic Router Configuration Topology Diagram 192.168.1.0/24 192.168.2.0/24 192.168.3.0/24 PC1 Fa0/0 S0/0/0 DCE S0/0/0 Fa0/0 PC2 ----- R1 R2...

Q:

Lab - Configuration and OSPF Topology G 0 / 0 / 1 G 0 / 0 / 0 R 2 1 0 . 1 . 1 . 0 / 3 0 . 2 . 2 G 0 / 0 / 0 . 1 R 1 G 0 / 0 / 1 . 1 S 1 FO / 6 FO / 5 PC - A 1 9 2 . 1 6 8 . 1 . 0 / 2 4 Addressing...

Q:

Overview and Objectives This case study allows students fully Design a complex network using skills gained throughout the course but build and configure only a prototype as seen in the following...

Q:

Cisco Networking Configuration Just configuration Use Packet Tracer to complete this lab. 203.0.114.0/24 PPPoE with CHAP client auth only Gig0/0 Se[/0/0 (2301 Seo/0/1 Sloud PT-Empty Digkal Subscriber...

Q:

Lab - Use Ping and Traceroute to Test Network Connectivity Topology Addressing Table Device Interface IP Address / Prefix Default Gateway R 1 G 0 / 0 / 0 6 4 . 1 0 0 . 0 . 2 / 3 0 N / A 2 0 0 1 :db 8...

Q:

Objectives Part 1. Perform basic router configuration (6pts) Part 2. Configure OSPF (36pts) Part 3. Configure DHCP (24pts) Part 4. Configure switch security (53pts) Part 5. Configure ACLs (30pts)...

Q:

Lab 7 Configuring Static Routes Name: Overview The overall objective of this lab is to configure static routes on two routers so that there is a network connection between the computers in the two...

Q:

PART 3 : CONNECTIVITY BETWEEN THE SITES We now have connectivity between the devices connected to R 1 and R 2 . In this section, you will establish connectivity between the sites and configure OSPF...

Q:

Lab Task 4: Configure R1 for Inter-VLAN Roliting Configure the router on the Office 1 network to allow multiple VLANs to communicate on the network. Perform steps 14 on R1. 1 Enable GigabitEthernet...

Q:

You have 1000 shares outstanding, with a stock price of $120. The cost of capital is 20%. Your company is expected to pay dividends of $20/share each year, including this year. You announce that this...

Q:

Answer the following questions. a. What are the strengths of Professor Waddocks analysis? What are the weaknesses? What does the fact that there were frauds and unethical behavior long before the...

Q:

Profit maximization can be a goal of a company. Who primarily benefits from profit maximization? Shareholders Customers Senior executives Employees

Q:

Compared with half a century ago, adoption has become _ _ _ _ _ _ _ _ _ common, but it is more open and acceptabl e , so we probably discuss it _ _ _ _ _ _ _ . fill in the blanks more or much less or...

Q:

Within the White-Collar Occupations, where do Females have the strongest and weakest representations in the Federal Service?

Q:

What are the Five Phases of SDLC? Explain each briefly.

Q:

How can Change Control Procedures manage Project Creep?