Question 1 Lab #1 Create the following circuits and verify the functioning Logic.ly is a software to design logic circuits. It lets you drag and drop components onto the editing surface and manipulate them easily with your mouse. Compete the truth table In T Basic instructions In 0 To add a component to the document, drag it from the component picker on the left side of the window to the editing surface on the right. Drop it at any location on the editing surface by releasing the left mouse button. 1 loglely - www ...DCINA.RS Design AND, OR, NOR, NAND, XOR and XNOR circuits. Draw the truth tables component picker the editing surface Question 2 For the following circuit, give the Boolean expression off and draw the truth table Design the circuit on logic.ly and verify the correctness of your truth table a To select a single component_ click it with your mouse. It will be highlighted blue to indicate that it has been selected. b To select multiple components, click on an empty area of the editing surface and drag the selection rectangle around all of the components in To delete a component from the document, select it, and then click the Delete button the upper tool bar. To create a connection click a component's output pin (a circular connector, usually on the right side), and drag a wire to an unconnected input pin. Basic components A Push Button outputs a low (false) signal by default or a high (true) signal when it is pressed down A Clock oscillates between a high (true) and low (false) signal over a set period of. time, which may be configured. It's state is changed automatically by the simulation. . AND, OR, NOR NAND... Gates: will perform the Boolean function on its input signals