Refer to Table S6.1 - Factors for Computing Control Chart Limits (3 sigma) for this problem. Sampling 4 pieces of precision-cut wire (to be used in computer assembly) every hour for the past 24 hours has produced the following results: Hour R Hour R Hour x R Hour X R 0.85" 1.26 1 2 3 4 3.15" 3.00 3.12 3.29 2.97 2.86 0.76" 1.18 1.43 1.21 1.22 0.37 3.15" 2.65 3.02 2.85 2.93 2.97 7 8 9 10 11 12 1.11 0.53" 1.13 0.71 1.33 1.22 0.40 13 14 15 16 3.11" 2.73 3.22 2.94 2.76 2.64 19 20 21 22 23 24 3.41" 2.89 2.65 3.18 2.94 2.74 1.66" 1.14 1.03 0.46 1.58 0.97 5 6 17 18 0.50 1.48 1.34 Based on the sampling done, the control limits for 3-sigma x chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Based on the sampling done, the control limits for 3-sigma x chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCL;) = inches (round your response to three decimal places). Lower Control Limit (LCL) = inches (round your response to three decimal places). Based on the x-chart, the wire cutting process has been The control limits for the 3-sigma R-chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCLR) = inches (round your response to three decimal places). Lower Control Limit (LCLR) = inches (round your response to three decimal places). Based on the R-chart, the wire cutting process has been IN CONTROL OUT OF CONTROL