Question: Worker element (min) Machine element (min) a (0.90) D (1.97) C (2.84) e (3.76) (264) The continuous timing method was used to obtain the times

Worker element (min) Machine element (min) a (0.90) D (1.97) C (2.84) e (3.76) (264) The continuous timing method was used to obtain the times for a worker-machine task. Only on cycle was timed. The observed time data are recorded in the table above. Elements a, b, c, and e are worker-controlled elements. Element d is machine controlled. Elements a, b, and e are external to the machine-controlled elements, while element c is internal. There are no irregular elements Al worker-controlled elements were performance rated at 70%. The PFD allowance is 10% and the machine allowance is 15% Determine the standard time for the cycle. 3.31 minutes O 2.90 minutes 0 3.00 minutes 0 2.69 minutes

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related General Management Questions!

Worker element (min) Machine element (min) a (0.90) b (1.97) C (2.84) e (3.76) d (2.64) The continuous timing method was used to obtain the times for a worker-machine task Only on cycle was timed....

8 ! DO The continuous timing method was used to obtain the times for a worker-machine task. Only one cycle was timed. The observed time data are recorded in the table below. Elements a, b, c, and e...

THERBLIG: A therblig is a basic motion element, the basic building block of virtually all manual work. The 17 therligs were defined by Frank Gilbreth, who devised the word therblig by spelling his...

3. (20 points total) The continuous timing method in direct time study was used to obtain the times for a worker-machine task as indicated in the table below. One part is produced each cycle. The...

Ind. Engineering steps pls 3. (20 points total) The continuous timing method in direct time study was used to obtain the times for a worker-machine task as indicated in the table below. One part is...

I want the solution NOW please!!! (b) In order to obtain the times for a particular worker-machine task, the continuous timing method was used. Only one cycle was timed, as shown in Table Q3(b)....

3. The continuous timing method in direct time study was used to obtain the element times for a worker-machine task as indicated in the table below. Element c is a machine controlled element and the...

Please answer number 5 with information from question 1 A worker-machine cycle is direct time studied using the continuous timing method. One part is produced each cycle. The cycle consists of five...

1) The continuous timing method was used to obtain the times for a worker-machine task. Only one cycle was timed. The observed time data are recorded in the table below. Elements a, b, c, and e are...

What is a difference between a cell in the G1 phase and a cell in the G2 phase? A cell in the G1 phase would have more DNA in its chromatids than a cell in the G2 phase DNA replication occurs in the...

True or false. Prime rate is commonly used as the benchmark rate for the floating rate component of an interest rate swap.

As the manager of Smith Construction, you need to make a decision on the number of homes to build in a new residential area where you are the only builder. Unfortunately, you must build the homes...