Question: In a sequential batch machining operation, setup time is 1.2 hours and batch size is 165 units. The cycle time consists of part handling time

In a sequential batch machining operation, setup

In a sequential batch machining operation, setup time is 1.2 hours and batch size is 165 units. The cycle time consists of part handling time of 37sec. and processing time of 2.39 min. One part is produced each cycle. Tool changes must be performed every 14 parts and this takes 1.5min. Determine the average production rate (pc/hr) (answer to 2 decimal points)

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related General Management Questions!

3 . 2 In a sequential batch machining operation, setup time is 1 . 5 hours and batch size is 1 2 0 units. The cycle time consists of part handling time of 3 0 s e c and processing time of 2 . 8 5...

In a sequential batch machining operation, setup time is 1 . 9 hours and batch size is 2 3 9 units. The cycle time consists of part handling time of 3 4 sec . and processing time of 3 . 1 6 min. One...

In a sequential batch machining operation, setup time is 2.2 hours and batch size is 188 units. The cycle time consists of part handling time of 33 sec. and processing time of 3.43 min. One part is...

Chapter 3 In a batch machining operation, setup time is 1.5 hours and batch size is 80 units. The cycle time consists of part handling time of 30 sec and processing time of 1.37 min. One part is...

1. In a batch machining operation, setup time is 1.25 hours and batch size is 90 units. The cycle time consists of part handling time of 45 sec and processing time of 1.5 min. One part is produced...

1.In a batch machining operation, setup time is 1.25 hours and batch size is 90 units. The cycle time consists of part handling time of 45 sec and a processing time of 1.5 min. One part is produced...

Q1 A flow line mass production operation consists of eight manual workstations. Work units are moved synchronously and automatically between stations, with a transfer time of 15 sec. The manual...

3 . 2 In a sequential batch machining operation, setup time is 1 . 5 hr and batch size is 1 2 0 units. The cycle time consists of part handling time of 3 0 sec and processing time of 2 . 8 5 min. One...

In a batch machining operation, setup time is 1.5 hours and batch size is 80 units. The cycle time consists of part handling time of 30 sec and processing time of 1.37 min. One part is produced each...

type answers DO NOT WRITE ON PAPER!!! 'ou have only one attempt at this assignment, however the assignment is open book and notes and is not timed. The naterial covered on this quiz taken from...

Write a paper on Actionless action. And respond to the following: identify any aspects of Wu Wei that would be practical in the busy lives of city dwellers, especially those living in the west....

Solve Prob. 13.59, assuming that the elastic cord has an undeformed length of 450 mm and a spring constant of 150 N/m. Note that the cord becomes slack during part of the motion.

With reference to the case study, discuss what additional measures CMB could have implemented to enhance its adoption of blockchain technology and integration within the financial industry.

Under Project scope Management knowledge Area perform the tasks Under the Planning Process Group. Similarly perform the 2 No tasks under "Monitoring & Controlling Process Group" all, as they apply to...