Question: In an orthogonal cutting operation, the tool has a rake angle = 15 degrees. The chip thickness before the cut = 0.21 mm and the

In an orthogonal cutting operation, the tool has a rake angle = 15 degrees. The chip thickness before the cut = 0.21 mm and the cut yields a deformed chip thickness = 0.67 mm. Calculate the shear plane angle for the operation.

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related General Management Questions!

Question 2 " In an orthogonal cutting operation, the tool has a rake angle = 1 5 degrees. The chip thickness before the cut = 0 . 2 3 mm and the cut yields a deformed chip thickness = 0 . 6 4 m m ....

1. Shear plane angle and shear strain: In an orthogonal cutting operation, the tool has a rake angle = 15. The chip thickness before the cut = 0.31 mm and the cut yields a deformed chip thickness =...

In an orthogonal cutting operation, the tool has a rake angle = of 15. The chip thickness before the cut = 0.30 mm and the cut yields a deformed chip thickness = 0.65 mm. Calculate (a) the shear...

An orthogonal cutting operation is performed using a rake angle of 1 5 . Chip thickness before the cut = 0 . 0 1 2 in and width of cut = 0 . 2 2 0 in . The chip thickness ratio is measured after the...

An orthogonal cutting operation is performed using a rake angle of 1 8 on a work material whose shear strength is 2 8 0 MPa . The chip thickness before the cut = 0 . 3 1 m m and width of cut = 2 . 5...

In an orthogonal cutting operation, the following data has been observed - Uncut chip thickness - 0 . 1 5 0 mm , Width of cut 6 mm , Cutting speed 5 m / s , Rake angle - 1 0 0 , Cutting force - 5 0 0...

An orthogonal cutting operation is performed using a rake angle of 14 degrees, to= 0.017 in and w = 0.1 in. The chip thickness ratio is measured after the cut to be 0.61. Determine the chip thickness...

An orthogonal cutting operation is performed using a rake angle of 30 degrees, to-0.014 in and w = 0.19 in. The chip thickness ratio is measured after the cut to be 0.63. Determine the chip thickness...

2 0 . 5 ( A ) ( USCS units ) A turning operation is performed using a rake angle of 1 5 . Cutting speed = 2 0 0 f t m i n , feed = 0 . 0 1 2 i n r e v , and depth of cut = 0 . 1 0 0 i n . The chip...

Consider the straight turning operation of a AISI 1 0 1 0 steel bar with a tool with a rake angle of 5 and a clearance angle of 3 , using the following operating parameters: cutting speed is 3 1 5 m...

Enumerate the most commonly used classifications of costs.

The dean of the business school wants to start offering this program starting 32 weeks from now. Using the information provided in Problem 15, (a) Calculate the probability of the program starting on...

A . This event would affect the balance sheet in an unpredictable manner. B . This event would decrease the book value of equily. C . This event would not affect the balance sheet. D . This event...

atch the compensation objectives with their meanings. Efficiency Efficiency drop zone empty. Fairness Fairness drop zone empty. Compliance Compliance drop zone empty. Improving performance and...